How to install a cell phone booster in your vehicle like a pro

December 10, 2015 — by KEN PERKINS


Vehicle Cell Phone Booster Installation

1. Do a “soft” install before the permanent installation
This means placing the booster unit in the location you want, running the antenna cords from the booster unit to the antenna locations, and running the power cord to the power outlet you plan to use. Do this first so you know all the components will fit and connect according to plan.

2. Place the booster unit in the location you’ve chosen
Usually the booster is placed in an inconspicuous location where it can be easily accessed if needed, like under a seat.

Check out this video for pro installation tips and read this post for more details.

3. Place the magnetic tower antenna on the roof of your vehicle
Why the roof? Because the metal roof acts as a shield. If your place the magnetic antenna on the trunk deck lid, it may pick up through the rear window the signals of your device antenna located inside the vehicle. This crossing of antenna signals causes a feedback loop condition called oscillation. Oscillation can damage the cellular network, so the FCC (and Industry Canada) require all cell signal boosters to auto-detect the condition. When a booster detects oscillation, it immediately reduces power, and therefore signal boost, until the condition is corrected. If reducing power doesn’t correct the oscillation, the booster will shut down, and will not restart until the oscillation condition has been corrected. The only way to correct or prevent oscillation is to move the two antennas further apart, or to employ a shield (like your vehicle roof) between them so they can’t pick up each other’s signals.

4. Secure the device antenna inside the vehicle in the location of of your choice
If the booster will provide signal to passengers, you will probably want to secure the device antenna in a central location so signals can be distributed to all occupants of the vehicle.

5. Run the cord from each antenna to the booster unit
Make sure power is disconnected, then connect each antenna to its proper connection on the booster unit. The connections are clearly labeled. Always disconnect power before connecting any antenna to the booster unit. Connecting an antenna to the booster while it is powered can damage the booster!

6. Run the power cord from the booster to the power outlet, but don’t plug it in just yet
Before plugging in you may want to hide any excess power cord length. IMPORTANT: Plug the power cord into the booster first, then plug the other end into the power outlet. Plugging a cord that is connected to power into your booster can damage the unit! ALWAYS dIsconnect the power cord from the power outlet before plugging into the booster unit.

7. When everything is installed as you want and the antennas and power cord are connected to the booster unit, plug the power cord into the power outlet. Your custom vehicle installation is done!


Did you like this post? Find it helpful? Do you have questions about this topic? Please let us know how we’re doing by commenting below.


Related Posts:

Cell Phone Signal Booster FAQ

How Does a Cell Phone Booster Work?

What Do the Bars on Your Phone Mean?


TAGS: installation

For buildings greater than 7500 sq ft, we recommend our WilsonPro brand of products.
signal bars
Improve your signal up to 32x