DC Hardwire Power Supply 6V/2A | 859923

email me this page
Email me this page

Works on every network, for any carrier.

Product Description

12V DC to 6V DC 2A, Hardwire DC Jack, works with Drive 4G-X, 3G-X, 4G-M, 3G-M.
12V DC to 6V DC 2A, Hardwire DC Jack, works with Drive 4G-X, 3G-X, 4G-M, 3G-M.
Read More…
Need it sooner? Try one of our online retailers to get your cell phone signal booster now.


Model Number:859923
Price$ 24.99
In stock

Review Snapshot

Ratings Distribution


    Showing 10 out of 2 Questions

    Asked by Dennis 3 months ago

    Question: I just purchased a 4G-X OTR for use in our RV. We will normally be hooked up to electric when using it. I understand there is a 120 volt plug in power supply. Which one should I use? I read a customer review that said the 12vdc output model increased the throughput of the amplifier compared to the 6vdc version. He also mentioned the 12vdc caused the amp to run hotter. Can you help me make a decision? Thanks!

    Answer: Thank you for your question! I would suggest the 6V power supply since 6V is what's recommended for the system to work properly. Customers have also used 12V before and have seen improvement but have seen problems in the long run since it does overpower the system and doesn't last and has potential to damage the system with that much power. We don't recommend the 12V due to these issues. If there's any other questions that need to be addressed, please give us a call at 866-294-1660 or contact our online support at: [email protected] Thank you!

    Was this question helpful to you? Yes: 1 No: 0

    Asked by tspirlock 2 years ago

    Question: will this work for the Drive 4G-X. the power supply cable that came with it has melted to fuse inside it

    Answer: Thank you for your question! We are sorry to see that this has happened. Yes, the 859923 will work with the Drive 4G-X. Please reach out to us for further questions. You can reach us here: [email protected]

    Was this question helpful to you? Yes: 0 No: 0

    This is a consumer device.

    BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your provider’s consent. Most wireless providers consent to the use of signal boosters. Some providers may not consent to the use of this device on their network. If you are unsure, contact your provider. You MUST operate this device with approved antennas and cables as specified by the manufacturer. Antennas MUST be installed at least 20 cm (8 inches) from any person. You MUST cease operating this device immediately if requested by the FCC or a licensed wireless service provider.


    E911 location information may not be provided or may be inaccurate for calls served by using this device. Please note, the four largest carriers, namely, AT&T, T-Mobile, Verizon and Sprint, and more than 90 regional carriers have given a blanket consent to all boosters meeting the new certification standards