Low Profile Antenna (SMA-Male) | 311106

email me this page
Email me this page

Works on every network, on any carrier.

Product Description

4.125 x 2.875 x 4.5 in. Indoor Mobile cellular low profile antenna, with 14 ft RG58 cable with SMA-Male connector.
Warning

Warning: This product can expose you to chemicals including Nickel, which is known to the State of California to cause cancer, and Bisphenol A, which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov

Specs

Model Number:311106
Frequency700-800 MHz3.4 dB
824-894 MHz2.2 dB
880-960 MHz1.2 dB
1710-1880 MHz1.4 dB
1850-1990 MHz3.2 dB
2110-2170 MHz4.3 dB
Antenna TypeOmni When Mounted Vertically
PolarizationVertical
ConnectorsSMA Male
DimensionsCoax Cable: RG58-14 ft/4.3 m, Height: 5 in/12.7 cm, Width: 1.5 in/3.8 cm
Price$ 24.99

Review Snapshot

Ratings Distribution


    Q&A

    Showing 10 out of 3 Questions

    Asked by BoB 3 months ago

    Question: What is the coverage of the Low Profile Antenna(311106)? Is the coverage greater than the interior antenna supplied with the 4G-X OTR?

    Answer: Thanks for the question! This antenna may work a little better but it's not going to be much difference than what you have now. Coverage is all going to depend on the signal the amplifier is receiving outside from the antenna. The weaker the signal is the less coverage you'll receive as well. If you need any other help, please give us a call at 866-294-1660 or email us at [email protected]

    Was this question helpful to you? Yes: 0 No: 0


    Asked by Tony 6 months ago

    Question: Will it work with the reach

    Answer: Thank you for your question! This antenna will not work with the Reach because this uses a SMA connection while the Reach uses an SMB connector. We have an adapter that makes SMA into SMB which can help you but we recommend only using the antennas that come in the kit. Please let us know if there's anything else we can assist with by calling our customer support at 866-294-1660 or our online support at [email protected] Thank you!

    Was this question helpful to you? Yes: 0 No: 0


    Asked by Gringo 9 months ago

    Question: Will this antenna work with a Drive 4G-X OTR setup

    Answer: Thank you for your question! Yes, it's possible! Please let us know if there's anything else we can assist with by calling our customer support at 866-294-1660 or our online support at [email protected] Thank you!

    Was this question helpful to you? Yes: 0 No: 0


    BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your provider’s consent. Most wireless providers consent to the use of signal boosters. Some providers may not consent to the use of this device on their network. If you are unsure, contact your provider. You MUST operate this device with approved antennas and cables as specified by the manufacturer. Antennas MUST be installed at least 20 cm (8 inches) from any person. You MUST cease operating this device immediately if requested by the FCC or a licensed wireless service provider.

    Warning.

    E911 location information may not be provided or may be inaccurate for calls served by using this device. Please note, the four largest carriers, namely, AT&T, T-Mobile, Verizon and Sprint, and more than 90 regional carriers have given a blanket consent to all boosters meeting the new certification standards